Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 8 - Jul 13
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Gorilla Water Based Wood Glue Natural Wood Color, Indoor-Outdoor Use 4oz (4 Pack)Gorilla Water Based Glue Bottle, Natural Wood Color, Indoor Outdoor Use, 4 Ounce (Pack Of 4) Gorilla Wood Glue is an adhesive that woodworkers, carpenters, and hobbyists trust for their woodworking projects. Gorilla Wood Glue, a PVA glue, offers the benefits of an easy to use, water based adhesive, with Gorilla strength. This PVA glue is incredibly water resistant and dries a natural color that offers an invisible bond line for your projects. About
Gorilla Water Based Glue Bottle, Natural Wood Color, Indoor-Outdoor Use, 4 Ounce (Pack Of 4) Gorilla Wood Glue is an adhesive that woodworkers, carpenters, and hobbyists trust for their woodworking projects. Gorilla Wood Glue, a PVA glue, offers the benefits of an easy-to-use, water-based adhesive, with Gorilla strength. This PVA glue is incredibly water-resistant and dries a natural color that offers an invisible bond line for your projects.
About this item
- Gorilla Wood Glue is an adhesive that woodworkers, carpenters, and hobbyists trust for their woodworking projects. Gorilla Wood Glue, a PVA glue, offers the benefits of an easy-to-use, water-based adhesive, with Gorilla strength.
- This PVA glue is incredibly water-resistant and dries a natural color that offers an invisible bond line for your projects.
- The hardest of exotic woods, like ebony, may present some glue absorption problems and may be too smooth for gluing. Also, harder woods, when burnished during planing, present problems for gluing as the surface gets very shiny and slick.
- For best results, it is essential that the wood surfaces are prepared prior to the application of glue. For laminating, the surfaces should be planed smooth, leaving the board surface free from machine marks, tear-out, and snipes. Also, be careful to avoid burnishing and end snipes.
Instructions
Directions: Clean and dry surfaces to be bonded. Apply glue generously to surface. Join and clamp for 20-30 minutes. Parts should fit tightly. Excess glue can be removed with clean, wet cloth or scraped off after glue dries. Allow bond to dry for 24 hours. Remove applicator tip to clean out glue build-up. Close cap after use. Store at room temperature. Do not freeze. If glue thickens or separates, shake vigorously until restored to original consistency. Store away from children and animals.
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.3 ★★★★★
Based on 493 reviews
Sort
Product Reviews
★★★★★ 5
Quality product you
Model: 18 SqFt(1.7 SqM), Model: 18 SqFt(1.7 SqM)
Summary: Great quality product, priced right. Cuts and installs easy-follow the instructions people!! PRO TIP-you don’t need to cover every square inch. OVERKILL!! Think about it-when a bell rings you could put your fingers on the edge and silence it right? Same rules apply here. A strip or square will isolate the vibration and notice when placed correctly— knock on the surface and see what vibrates or what part makes the loudest drowning and that’s a good clue of where you should put a piece of this…unless you’re trying to use it for temperature insulation no need to go ape on it. If you look at the bottom of a stainless steel sink, it’s got a stripe or a small sticker of insulation that keeps it from rattling. You can do that here. What’s important to note is the instruction specifically say use a roller to roll the ribs out until it’s smooth that way you’ve got maximum adhesion. I see a lot of pictures and videos from people that finished their install and didn’t follow this simple instruction. It makes sure that it’s stuck down before you put all your paneling and carpet back in and it’s a small step with a cheap wooden roller it’s easy. I’ll say the installation with this product is a breeze. You can use sharp scissors or a blade. It does get gummy after a while, and you may need to clean off your blade or your scissors, but it cuts very well and the ribs make it easy to size in space the thickness is fantastic and the backing paper comes off quite easily. I’ve done lots of installations with Graphics emblems you name it and this product is very easy to use and represents good value.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 30, 2026
★★★★★ 5
Good stuff !
Model: 36 SqFt(3.4 SqM), Model: 36 SqFt(3.4 SqM)
This is an excellent product. Easily moldable, cuttable with good scissors or razor knife, very sticky, works great.
This pack was enough to do all 4 doors on a crew max truck, and I went wild on the fronts. I used 9 peices on each rear door which was just enough, and the rest on the fronts. I doubled up layers and even used some on the back of the door panels. If you follow the instructions and dont go wild you might even have extra left over.
It works just like you would imagine. Without doing the entire cab there will still be road noise but this helped noise, better audio, no buzzing door panels, terrific improvement.
It is kind of heavy, so extra weight is added to truck, but that really isnt a bad thing. It is noticable but in a good way.
Get it. Use it.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 20, 2026
★★★★★ 4
Good product
Model: 36 SqFt(3.4 SqM)
Easy to roll out. Works great
Why did you pick this product vs others?:
Fair price for the amount of coverage, good quality
Works well:
Easy to install, rolls out great. Forms to contours well
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 13, 2025
★★★★★ 5
Great product
Model: 36 SqFt(3.4 SqM)
I used this on the doors of a Toyota Tacoma, worked as it described. Reduced the road noise significantly.. Need to buy another box for the floor and roof of the truck..
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 15, 2026
★★★★★ 5
Great product - Add foam product for complete solution
Model: 36 SqFt(3.4 SqM)
Used in two cars with speaker upgrades. Easy to install but get the roller for assured adhesion.removes "tinnyness" from large metal resonators. Use with foam absorptive material for a complete system.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 14, 2026